Forum

No issues in combination with NX2s. I never noticed that piece before. I have broken the boa cable a few times though from resting the board's edge ...

Oh my goodness... Don't drop these! It's been hard man, I don't know how the binding companies do it. I measured every board in the house to get t...

  1. Yes 2. To make sure the risers don't move under the bindings. It's not weak; there's a gap between the top surface of your top she...

Carving produces much more edge pressure than skidding. Your new G4 @carveaddict75 is capable of holding turns at very high pressure in comparison to...

@mooncat1234 Thanks for joining, welcome to the forum! This should answer most of your questions...

Yeah, this is the primo setup for a G Series board. Same as I ride.

Thanks for doing that!   This seems more like an off-season job... I've got videos to produce and board to mount this week. I've been w...

I saw this a few days ago... Riding alone used to be how all the hardbooters leaned to carve. The pace is slow even if the speed is high; it takes ...

I like a few degrees of inward canting in combination with some back foot heel lift and front foot toe lift. How much benefit maybe depends on the ri...

Very true! Especially with wide boards...

Oh, it's definitely comparable, and you're gonna like it for sure! Really it's the only board that's comparable, and most test riders have preferred ...

Jasey had sent me a couple of boards with inserts and a plate to try a couple seasons ago. It was a very interesting test ride, my first time on a pl...

Yes and no... I designed them to be versatile, suitable for any day and any temp. So the main mitten is only thinly insulated, but protected from w...

746 is a lower durometer and more flexible. I recommend this one. I'm taking delivery of 300 pairs of the Trenched Forever Mitten in a week or two....

Thanks Man! Like the new studio? (It's also my bedroom and my office...) I could never figure out how to light The Boardroom properly, plus, it's h...